OK, I have a nice little 1907 in .32 auto, I began disassembly and all went well at first. I locked the slide back turned the firing pin/bolt assembly a quarter turn to the right and removed it. Now the troubles begin, I release the safety lever and gently let the slide travel forward. It should have moved forward and slid right off the frame along with the barrel and spring. What happened is that it traveled to about where it would be fully assembled and stopped. It resisted all my efforts and is definitely hung up on something. It can be moved to the rear, but hits something solid going forward. My fear is that the barrel was not aligned properly the last time it was field stripped? Any comments or suggestions appreciated. (to answer a couple of obvious questions, the mag is out, and yes it was disassembled before.....by me so whatever is wrong is on me.)