I’m trying to install an action into this stock, but the new style recoil lug is throwing me for a loop. I can’t get it to stay in place when installing a new barrel. The old style had a small nipple that fit into a cutout on the receiver. This new style doesn’t have said nipple, so it can spin around when the barrel gets tight. What is the secret to doing this right?
Are you using the Action wrench? It has the indentation from the recoil lug. It's a bit oversized, but you should be able to shim the sides a bit to stop the recoil lug.
I have an action wrench, yes. But I have no idea what else you’re talking about. How do you shim the sides?
I think they're talking about fabricating some wedges that would hold the lug in the center of the mortise. From aluminum or wood. I believe that Northland Shooter's Supply sells an insert for their action wrench to hold the lug in place if it isn't pinned.
Exactly. Just how my mind works. I’m a problem solver. Sometimes it’s more difficult to explain than to simply DO. Good luck.
It is very easy to install an indexing roll pin or a screw on your recoil lug. I have had good luck with scope mount / ring sized Torx screws. Drill and tap a hole in the right spot, then grind the head of the screw until it fits the slot in the action perfectly. Even better than the factory dimples.
Posting Permissions
Reply With Quote
Bookmarks