Clean with alcohol, fit as necessary, scuff both surfaces with 180 grit, clean with alcohol again, use Loctite Red 263 if you need some time or 380 if you’re brave.
Clean with alcohol, fit as necessary, scuff both surfaces with 180 grit, clean with alcohol again, use Loctite Red 263 if you need some time or 380 if you’re brave.
Good to know. Thank you.Originally Posted by gbflyer
I noticed that some Loctite 263 is labeled "RED threadlocker" and some just say "Loctite 263 Threadlocker". Is there a difference between them?
It's just the labeling as far as I know. I did come across this which may be of interest to you.
https://www.exdron.co.il/images/Prod...-datasheet.pdf
It is definitely of interest. Thank you.
Did you use silver or silver with cadmium. The guys who re-solder Remington bolt handles on use a higher temp stuff.
The Dunning-Kruger effect is alive and well.
No, that was my problem. I didn't know stainless required special handling. The links that 8mm posted explain about stainless very well.
Posting Permissions
Reply With Quote
Bookmarks