Hello all,

I removed my barreled action from the Accustock to sand down a few contact points on the stock. There is a little washer I believe was on the front action screw (I dropped the screw when removing so lost orientation) and I can't figure out where it goes?

It has the DBM and I can't find info anywhere as to the correct placement of the washer. Does it go between the head of the front action screw and the magazine holder body?

The front action screw hole got buggered up, however, I was able to mostly save it, albeit a little stiff running the screw in so I had to purchase a longer screw to use so it can meet the threads.

Thank you all in advance.