Yes, it will control the height of the magazine in relation to the mag catch.
Yes, it will control the height of the magazine in relation to the mag catch.
"As long as there's lead in the air....there's still hope.."
Ok, I see. So do I just have to set the washer down and carefully put the screw through the DBM frame and washer so it doesn't fall all around during installation?
Sorry for the barrage of questions, however, I noticed that the washer is slightly concave and favors a concave seating position. The only place I see this is between the screw head and the DBM body, considering the bedding block is completely flat.
I also noticed my owners' manual doesn't list this washer or the cylindrical piece the rear action screw passes through. Just trying to make sure reinstallion yields no problems.
Trial and error is where you are since you lack confidence in a very knowledgeable gunsmith.
Install it where you want. Check function of mag catch/release and bolt operation. Problem, move washer to a different location. Test again. Problem, move washer etc...etc....
The Dunning-Kruger effect is alive and well.
My intentions were not to doubt anyone's expertise. I apologize as I am new to this forum and don't know everyone's background. I will follow what sharpshooter has advised.
The Dunning-Kruger effect is alive and well.
Understood! Yes I'll give his expertise some credit and try what he said.. if no luck... it will be back to the drawing board
Brydawg512,
do you have any feedback on the stripped front action screw problem?
Bookmarks