Here's what I can tell you...
if you have a dial caliper, take the dimension at the thickest point of the barrel and divide by 2....
measure from the top of the barrel to top of the receiver and add that measurement assuming a properly machined receiver, a good 4' level is your friend...
add the distance to the center of the new scope, this should be available from DNZ (1.05)
I looked for the dimensions on the axis II and had no luckon schematics. :/
you should have the total from the axis of the bore to the crosshair at this point...
I'm in Sanford, and have a pretty solid history of getting scopes right, if I can help, LMK...
Bookmarks