I think I had two issues going on. First, the two piece bases were not in complete alignment with each other. If I ran a level across the front and rear bases, then they were not even...not huge but slight. It could be the holes in the action or the bases themselves. That’s why I was thinking about a one piece base.
The other issue I had was with the Burris Signature Rings and the plastic inserts. One of them kept falling out of alignment with the top of the ring during installation. I finally flexed it outwardly enough so that friction kept it in place long enough to tighten the ring down. I don’t remember it being a problem when the rings were brand new. Perhaps it’s because they were several years old.
Bookmarks