Just got a PTG bottom metal and aics mag for my 243 ackley. It took quite a bit of dremeling on both the stock and bottom metal to get it all to fit together, which I kind of expected.
When cycling the bolt with a loaded mag, the bolt will hang up unless I cycle it very fast. The back of the case is just high enough to not seat in the bolt face like it should. I have already tweaked the lips on the mag some, which made a pretty big improvement, but I was wondering if anybody had any other tricks for this particular cartridge in aics mags? I know the sharp shoulder makes it harder to feed.

It's a model 10 factory dBm. Now in an hs precision stock.


Thanks,
Michael

Sent from my SM-G930V using Tapatalk