So in another thread some asked about how pressure testing gets done. I need a little break from what I'm doing, so here is a pretty quick and dirty view of the process we did.

Cast the chamber and take GOOD, careful measurements at various points(stated in the instructions), then take good, careful measurements of the outside diameter of the barrel over the same points of the chamber. Carefully clean and bond the strain gauge to the barrel, looks like this.


Then just basically enter the measured dimensions into the program, follow directions, etc. Been too long ago, so I don't recall the specific calibration used. May have been reference ammo purchased from SAAMI, may have been a particular lot of ammo that discussed with the mfgr. In any case there was some cross-checking of numbers to ensure a reasonable level of accuracy.

So plug-in your strain guage to the cable going to the Pressure Trace, and connect(bluetooth) to your laptop.




Enter your current environs and shoot away!



For a bonus bit of testing we just completed over TurkeyDay, small primer testing.
I've been watching the fervor over Creedmoor brass being offered with small rifle primers. Better ignition, better pressure "handling ability" and various other claims of mystical properties.

I bought some Lapua small primer brass, and some Norma large rifle brass. Did two different loads, 100gr Sierra hp's, loaded with 748; Then 140gr Hornady SP's and IMR 4451. Used Wolf standard large primers, and Wolf Small Rifle Magnum primers. Same jump to lands, same powder charge, same brass for both loads. 748 normally doesn't have any issues in the Creed, but as it is now quite old tech, it will be harder to light than current powders. 4451 because it is the new hotness.
The small mag primers with 748 had terrible hang-fires, and a few rounds that flat didn't ignite. Once we pulled them apart, the primers had in fact ignited, but didn't have enough oomph to ignite the powder charge properly. No issues with the large, and no issues with the 4451.

Interestingly, the burning curves and rifle pressures were statistically the same, even with hang-fires. Also a good visible example why staring at primers don't tell you shyte about actual pressures in your rifle.









Had to block-out the rest of the curve in the above trace, because I didn't have the wire properly secured, and introduced noise, when I drug it across the bags during recoil and ejection..... I know, a DFO...