Was wondering when the Axis is supposed to engage the sear? Mine does not engage until roughly 1/4 to 1/3 of downward bolt travel. It takes a significant amount of bolt lift effort to lift the cocking piece off of the sear and back into the cocked position. There is also a ~1.9mm difference between the firing pin sitting on the sear ready to fire and when the bolt is simply cocked (more compressed). I was thinking about modifying the ramp but I'm not entirely sure if there would be any problems having the sear (likely) engage at the end of the bolts forward travel, or how much a new bolt sleeve would cost if I booger mine up. Anyone know?