Unscrew it, if it does not back out, it has a nut underneath.
The bipod I chose to install uses the front swivel screw as its anchor. Unfortunately, my swivel screw is installed too deep, thus making the bipod adaptor unusable.
The fix is for the swivel screw to sit up higher, i.e., to back it out of the stock by a turn or two. BUT, the stock is synthetic. So I don't know if the screw is actually screwed into the stock or glued into the stock.
Can anyone shed some light on this issue? Savage doesn't seem to want to answer this question.
Thanks for any help, John
Unscrew it, if it does not back out, it has a nut underneath.
"As long as there's lead in the air....there's still hope.."
Remove the action and look to see if there is a "T-Nut" embedded in the stock. If so just back out stud and replace with a thin washer or two that will hold the stud out far enough to fasten the bipod mount to it.
If there is NOT a nut embedded in the forend for the sling swivel this is a good time to install one. Kits available from Midway or Brownells but one can use a plain old hardware store T-Nut that fits the threads on the sling swivel if not one with wood screw threads.
Dremel out a flat spot on the bottom of the barrel channel that will let the T-Nut fit without touching the barrel when the barreled action is installed in the stock. Apply some 5 Minute Epoxy to the bottom of the T-Nut and insert in prepared hole.
Put some wax (candle wax works great) on the sling swivel threads and tighten with washers that hold the head of the stud in the right place.
Go shooting.
Bookmarks