Bottom Bolt Release to Top Bolt Release Mod Done

[Zero333]

Yea I hear ya. If I had a mill I might consider going that route. I really hate the bottom bolt release, and I'm sure everyone else does too.

This week I have to convert my brothers left hand receiver to top bolt release. I'll try not to brake it when bending the lever.

[RC20]

Yea I hear ya. If I had a mill I might consider going that route. I really hate the bottom bolt release, and I'm sure everyone else does too.

This week I have to convert my brothers left hand receiver to top bolt release. I'll try not to brake it when bending the lever.

Break? (or brake) don't stop, I don't get to do that often........

Well you are set to correct, always like having a good fallback.

I don't know you would need a milling machine though it would be nice (and in bulk like CDI of course)

I think I could do it with the grinder and then clean up with a file and then sand down to a finer finish.

Still chewing.