conversion from .223 to 300wm

[110fp]

Hello all


I have a 110 fp tactical in .223 and would like to install a 300wm barrel.

would I only need to change the bolt head or should I change the whole thing?

any help would be appreciated conversion

[Txhillbilly]

Bolt Head-Firing Pin-Magazine Box and Follower/Spring. If your bolt has the extended baffle,it would also need to be swapped out.

[hereinaz]

The bottom of the action also needs to be milled out for long action. And, you may need to change the stock if it is set up for short action. I don't know how the FP are set up.

[110fp]

I could just get a new bolt for the 300wm and keep the current one for my .223 right?

[110fp]

The bottom of the action also needs to be milled out for long action. And, you may need to change the stock if it is set up for short action. I don't know how the FP are set up.

it is already a long action so I would just need to change the magazine

[Robinhood]

it is already a long action so I would just need to change the magazine

Probably not. But if you repeat it 3 times you wont have to address it until you find out your magazines don't fit.

[scionxb3003]

There were 2 110 actions cut. The bottom was milled for 308, and 30-06 length cartridges. So if you do have a 223 that may be something to look at first. Can't find the picture of the actions but this should still get the idea across.

[110fp]

There were 2 110 actions cut. The bottom was milled for 308, and 30-06 length cartridges. So if you do have a 223 that may be something to look at first. Can't find the picture of the actions but this should still get the idea across.

Thank you that is very helpful