Hi folks,

First, let me state I'm new to bolt actions and even newer to blind mag bolt actions. I just rec'd my Boyds stock for my 11 Hog Hunter. Prior to jimmying around with the mag, while in the original stock, the action cycled quietly as it should. I read here about how to remove a blind magazine and followed the directions to successfully get that stubborn part out. I replaced everything into the new stock and now each time I work the bolt it squeaks like a neglected swing set. I broke it all down and put it into the original stock and though subdued, it squeaks in there now too. I must have jacked something up - hopefully something simple.

It makes no noise in either stock without the blind mag installed so that must be the culprit. Any suggestions on how to remedy this situation?