Welcome to the forum
You should be able to push the rounds into the mag without much trouble by setting on top of mag feed lips and pushing down
It can be a little trouble due to the scope but set the round on mag lips and push straight down
Make sure you do not have the round too far back that the shell is hitting the back of the mag when your trying to install
If that does not do it I would check to make sure that the mag is setting in the stock correctly. A L clip is usually needed to keep mag in correct position
Feed lips on mag should be centered below bolt and just enough clearance to clear the bolt head when cycling
You can also use shims or epoxy putty
I hope this helps, you have a good rifle
Jack
Bookmarks