Don't seal the wood. You want a porous and rough surface for the compound to adhere to.
When I bed an action I remove as much as a 1/4 inch of wood in most places, I also take a 1/8" drill bit and drill small 1/8" deep holes all through the bedding area to create grab holes.
Make sure you use Devcon 10110 steel epoxy putty and Kiwi neutral shoe polish for a realease agent. Do not use accraglass, that stuff is a joke. Make sure you put modeling clay in the grooves on the barrel nut and use masking tape where you don't want the epoxy to go in. I even put shoe polish on all tape surfaces for an easier release. Wait a full 24 hours for separation.
As far as bedding the lug I only put three layers on the bottom of the lug, that way there is no room for play on the sides and front and back.
Charlie
Bookmarks