20MOA Rail on BAS-K or BAT-S ??

[Donnie]

The 110BA is advertised to have the 20MOA rail. Anyone know whether the BAS-K or BAT-S have 20MOA in the rail? Is there a definitive way I could measure?

[Balljoint]

The BAS/K i just purchased has a rail that came with it, is not marked BUT it's thicker in the rear than front, ether a optical illusion OR it's a 20 Mil Rail

[Donnie]

The BAS/K i just purchased has a rail that came with it, is not marked BUT it's thicker in the rear than front, ether a optical illusion OR it's a 20 Mil Rail

Same here. I'm trying to figure out how to measure it.

[Donnie]

I've confirmed the base is 0MOA.

[Balljoint]

If my rail is 0 moa i'll have to see if the Ken Farrel 20moa rail will fit 10BAS/K, went down to my gun room and looked at the Farrel i have it's a SAV -1-20 base

[Donnie]

If my rail is 0 moa i'll have to see if the Ken Farrel 20moa rail will fit 10BAS/K, went down to my gun room and looked at the Farrel i have it's a SAV -1-20 base

You'd have to remove the entire base on the rifle which sucks. Too bad the main scope portion is attached to the fore and side rails.

[Balljoint]

Sent email to Farrell asking if the base i have will fit my new BAS/K a SAV.RTS.1.20

[Balljoint]

Got an email from Farrel about my base told them had a 110 BAS/K rifle they said this is a long action rifle and my base is for short action, think i gave them some BAD info as it's a 10 BAS/K which is a short action so looks like it will work.