Check with CDI Precision, pretty sure they offere a setup for the older long-actions. You'll need a different stock though and you'll have to have CDI inlet it for you for their magazine bottom metal.
Hi guys!
I have an old 110 (lefty long) with the sidebutton mag release.
the mag dont work properly and wont seat corectly in the magwell
is there any other magazines and bottom metal i can use/modify to fit this action
or do i just throw the thing in the lake :)
Thx /Nils
Check with CDI Precision, pretty sure they offere a setup for the older long-actions. You'll need a different stock though and you'll have to have CDI inlet it for you for their magazine bottom metal.
"Life' is tough. It's even tougher if you're stupid." ~ John Wayne
“Under certain circumstances, urgent circumstances, desperate circumstances, profanity provides a relief denied even to prayer.” —Mark Twain
Probably just need to bend the tab on the side of the mag just a little so it will catch properly. They tend to bend in over the years and need a little adjustment.
I understand your frustration but I wouldn't throw it in the lake. A minute of your time and a small flat screwdriver should fix it right up.
If you do decide to swap it out a paid membership here to gain access to the classifieds would allow you to sell the old setup and help offset the cost of the new one. Lots of guys looking for old factory parts here.
A good wife and a steady job has ruined many a great hunter.
Thx! Ill look into the catchtab.... probably more hassle to ship from here then to by stuff from there :)
Bookmarks