Here's the scenario,

Got a tupperware stock I'm setting up for my fiancee. She's 4"11", so naturally I cut it down. With a 1" grind to fit recoil pad the LOP is not approx 12.5".

But, the screw don't match up with the ribs in the butt-stock. In fact they hit right at the edge of the ridge. I am thinking I need to fill the butt stock with something and then screw the pad into that.

But what?

I have Devcon, Fiberglass cloth and resin, and some PC7 on hand, as well as some scrap pieces of hardwood.

So what I'm currently thinking is fill the butt with fiberglass resin and get as much cloth in there as possible. Then I'll have the bottom of the pad, and it's screws covered in release agent, and set the pad into the liquid resin. Should just screw out after it set up, right?

Any thoughts or ideas?

Adam