I had my 1 year old Savage 10fp (in 308) out the other day and was working on shot groups and trigger control with a longer than usual stock. I was trying to get a decent length of pull on the rifle before I ordered a custom stock.
anyway the rifle is still pretty new to me and I was just getting it dialed in at 100 yard and was just a little bit low using 168gn Hornady match ammo. I went to dial the scope up and I ran out if elevation. ( Millet 4x16 mil dot mil dot).
After looking at some notes I realized I was running right on the edge of the come ups since the scope was mounted. This does not seem normal.
I was going to get a 20 mao rail later but that would still only leave me with 19 moa of come ups to work with.
How what do I need to check to figure out what off and how do I check it?
I have a Brownells ( i think) one piece rail right now. The rail itself measures pretty straight Same height at both ends.
Is the action of the 10fp flat or straight and level with the barrel??
Bookmarks