So... sent a gun with a bottom-bolt release off to a local 'smith. Long story short, the trigger was removed to facilitate the work in question and came back to me in a baggie. Didn't think anything about it until months later (now) when I'm getting around to putting everything back together and uhhhh... that thing don't fit back together the way I remember because there isn't any 'ear' for the bolt release - and one leg of the spring is much shorter than on my Target Accutriggers. Apparently I never looked that closely at the dang thing before, and so far I've struck out searching for pics/videos of what goes where.

If someone could snap a couple pics of where that spring goes in the overall scheme of things I would greatly appreciate it.

TIA,

Monte