ok it was simple, cut the pmag, take the floor plate off the savage mag, line everything up and pin it with finishing nails, trim nails with dremel, modify pmag follower to fit high enough in the savage mag for the last round, and trim off the entire bolt catch piece on the pmag follower so it fits in the savage mag
trip the plastic spacer on the savage mag so the pmag would fit flush, cut the savage floor plate to fit trim the locking tabs on it to fit with the new pins shorten the pmag spring and done pretty ez really

oh and use a cut off wheel with the dremel to make a flap at the front of the savage mag to bend back and shorten so that it works as a ramp to make sure the rounds are pushed back into the pmag for a smooth flowing mag


one more thing how do i get email notifications on this site,, had no idea any one commented and ill try and get more detailed pix in a few