Checked recoil lug, not bottoming out. The screws were too long, when I tightened them down all the way they stopped the trigger and bolt from functioning properly. I used washers to space it out enough to tighten down so both work. Was thinking that may have been the problem, checked it cranked down without the washers and it still had same issue. Checked back of stock and shaved out a little bit that I thought was rubbing, didn't fix it. Still wiggles. Everything tightened down it seems sturdy but if I apply sideways pressure on the barrel the back end of the action still slides to the side and the barrel moves over to the side in the stock. It doesn't bounce back to the original position.