One of my guns has a similar setup, and just barely fits. Remember yours will get a tad lower when you actually tighten up the rings.
Viper 6.5-20x50 with medium Signature zee rings, on Warne steel 2pc bases. The bases are almost the same as yours in height, but the 50m Viper would not fit with the 0 inserts in. If I raise it with the +10 inserts in the front and rear the scope will BARELY fit. I can slide a pc of paper between the scope and barrel, but cannot slide 2 pcs of paper between them. It is actually too low for me, so I just ordered a set of high rings for it.
[img width=600 height=450]http://i158.photobucket.com/albums/t106/pdog06_photos/march079.jpg[/img]
Bookmarks