After years of trying all different ways to dry my brass after cleaning with stainless steel pins I decided to try a method I'd been thinking about for a long time. Normally, I'd stand the cases up on a towel after spinning as much water out of them as possible. That is until the cats came along and knocked them over. This took a little time to make, but I hope it will make things easier down the road. Actually, I made two and each will hold 476 cases which is a good thing because I have a giant commercial tumbler.

This might have just been a waste of time, but I had a day to myself and felt like doing a little project. I just used some scrap plywood I had hanging around, cheap finish nails, some paint and sealed it all with polyurethane since I didn't feel like paying the extra for SS nails. I needed to make sure it would work with all my pistol brass as well as .17 Fireball up to .338 Lapua.