Axis XP II rings torque

[Rosco]

My SWFA 30mm medium rings specifications are 10lbs/in.

[domo]

My SWFA 30mm medium rings specifications are 10lbs/in.

most use rioght around 15 inch lbs of torque, but specifications may be particular to some scopes depending on the maker.

Thanks for your replies. I'm finally just getting back to this project. I searched and by the looks of things the rifle came with this:
Scope base - http://www.midwayusa.com/product/992...ear-axis-matte
Rings - http://www.midwayusa.com/product/242...ProductFinding

I've searched but the general torque suggestions vary a lot by type of rings.
Scope base torqued ? in/lbs
Ring bases torqued ? in/lbs
Ring caps torqued 10-15? in/lbs

[Rosco]

I was not able to find a specification sheet on the Weaver 2 piece base, but I would assume these are torqued either the same or almost the same to the Weaver Single piece base which many shooters use here. As for the rings I was able to find the manufacture page which lists the base thumb clamp screws at 25-30 in/lbs. and the Ring screws at 15 in/lbs.

Here is the link
http://www.vortexoptics.com/product/...30mm-rings-low

Also you could call IronSighter Company @ 734-326-8731 and ask Tech Support I am sure they would have an answer for the base.

[domo]

I was not able to find a specification sheet on the Weaver 2 piece base, but I would assume these are torqued either the same or almost the same to the Weaver Single piece base which many shooters use here. As for the rings I was able to find the manufacture page which lists the base thumb clamp screws at 25-30 in/lbs. and the Ring screws at 15 in/lbs.

Here is the link
http://www.vortexoptics.com/product/...30mm-rings-low

Also you could call IronSighter Company @ 734-326-8731 and ask Tech Support I am sure they would have an answer for the base.

Thanks again for your response. I searched the forums and the only post I could find concerning Weaver 2 piece base torque was http://www.savageshooters.com/showth...l=1#post250423
15-25 in/lbs