Boyd's Prairie Hunter stocks anyone

[buggybuilder]

The guard is too big for the slot in the stock. I will sand a little bit on the plastic trigger guard rather than the stock. Only need to take off about .030"

[campdude]

That's good to know and thank you
Would like to see pictures when your done.

[campdude]

Got the barrel chamber opened up and fit today, the only problems are with the bolts-screws that hold the stock to the barrel. I put a factory DBM in the stock, the front trigger guard screw is to short and the DBM screw by the Mag release is to long. Where can I find screws for these?

Thanks

[foxx]

Got the barrel chamber opened up and fit today, the only problems are with the bolts-screws that hold the stock to the barrel. I put a factory DBM in the stock, the front trigger guard screw is to short and the DBM screw by the Mag release is to long. Where can I find screws for these?

Thanks

Boyds sells them fairly cheap, but you can get the same thing at a hardware store and simply cut them a bit long, then grind or file to length. If the front one is too long, just grind it to length.

[ywhic]

If you go back to Boyds and look on that particular stocks' page you will see they note this and sell longer screws.. sorry..

[campdude]

Thanks foxx and ywhic no apology needed something I over looked and should have paid more attention.

[campdude]

I put the rear dbm bolt on the grinder to get it to the correct length and then took the trigger guard and ground just enough off it so that bolt would fit.

Thanks for the help guys

[campdude]

Finished up and just waiting on my 10 roung mag from Dark Eagle Customs.
Thanks to all that helped me