Newcomer here. Was hoping I could get some guidance with a problem I have with my scope mounting system for my Savage 116 in 300WM. I initially had a 2-piece Leupold set up, but couldn’t get a reasonable grouping in any bullet/load combination. I initially thought the problem was simply some bad habits of recoil anticipation, so I had a detachable muzzle break fitted to the rifle. However, the gunsmith that built the muzzle break pointed out that one of the scope mounting plates was loose (and no amount of tinkering would secure it). So I tossed that set up and went to a 1-piece mounting system, but then experienced the scope sliding forward after only three or four fired rounds, evidenced by the finish on the scope being scraped away by the rings even though I simply can’t turn the ring screws any tighter. At this stage I think I need to start from scratch with a new mounting system and was wondering what many of you guys use or recommend. Any suggestions would be appreciated.