check to see if the ( BAS) bolt handle screw is not tight
drybean
12FV 22-250. Action is all stock.
The bolt handle is pretty sloppy/wiggly/loose. Doesn't matter if it is open or closed. Is this something that is normal. Just seems a bolt shouldn't bounce around.
OK I tried tightening the hex head bolt on the back..It was definitely loose. So now I have the bolt snug, should I take this hex head bolt out and use some thread locker on it? Will the bolt come flying apart if I do?
Darrell
Last edited by DT400; 02-07-2014 at 06:58 PM.
check to see if the ( BAS) bolt handle screw is not tight
drybean
No you don't have to do that, now that it is tight it will be fine.
Dean
RUMs are like woman in Stiletto heals, you know they are going to put you in the poor house, but that has never stopped anyone from pursuing them.
OK thanks guys.
All done and ready for some Prairie Doggin' Sunday...Or as we put it "feeding the hawks". Where I go, shortly after we start shooting, a few hawks will show up and start chowing down even as will are still shooting. Pretty awesome to watch.
Darrell
Bookmarks