Quote Originally Posted by Scalian
That is what i was doing just wanted to check. Just got the tang free floated and it centered up the barrel really nice. Was off to one side a bit. Now i have to get some bedding compound ordered and give it a go.
Devcon Steel Putty is all I ever use anymore. I have tried a lot of different two part epoxies and Devcon worked so well I never tried anything else. I have also been told Marinetex is another good one but I have never used it so I can't comment on it personally. I will say stay away from JB Weld and similar stuff. It tends to run into places you don't want it as well as it has always been really brittle the few times I tried it. The best part about the Devcon is that is stays where you put it because it is a thick consistency, about the same as peanut butter. Another thing is that is does dry hard but isn't brittle. For a release agent use Kiwi natural polish as a release agent, works great and I have never had a glue in.

Devcon is a little pricey at around $40 for the 1 pound kit. It is plenty for probably 6-8 rifles. There is plenty of people on here wanting to use it for a single gun and the cost for 1 gun keeps them from buying it. I bet you could buy the 1 pound, use what you need then sell the rest to another member here to recoup some of your cost.

Just my .02
Dolomite