Billpa - where do you get the rear entry wrench and open ended spanner?
Billpa - where do you get the rear entry wrench and open ended spanner?
I made both. The rear entry wench was a left over from my Rem switch barrel days and I just cut the end of the spanner just enough to clear the barrel shank. I use them for two reasons. One, I can swap barrels without removing the scope/mounts and two, I can swap them almost anywhere, even on a bench at the range if I want.
BTW, I don't use them to pull factory installed barrels. I use this setup for those.
Bill
Each morning eat a live green toad, it will be the worst thing you'll have face all day.
Bookmarks