1/2 28 tpi
What is the thread size on a BAS and bolt body? Thanks in advance.
1/2 28 tpi
Last edited by stangfish; 11-17-2013 at 05:38 PM.
For some reason I was thinking it was 1/2"-28TPI.
I don't have my pitch gauge here as I leave it work most of the time, but glancing at a BAS here it seems to be a finer pitch than a small shank barrel I have here and I know that the small shank barrels are 1.055"-20TPI. I got up way to early this morning so perhaps its just my tired eyes.
204, 22 K-Hornet, 222, 223, 22-250, 22-250AI, 6BR, 243, 243AI, 6-06, 6-WSM, 250-3000AI, 270, 7-08, 7RM, 30BR, 308, 30-06, 375 H&H, 444 Marlin, 450BM, 458WM
Boots is correct.
The one who dies with the most toys still dies--except in Christ.
You are correct Boots. I don't know what I was thinking. Just stripped it down and verified.
Thanks for the verification, been a long day.
204, 22 K-Hornet, 222, 223, 22-250, 22-250AI, 6BR, 243, 243AI, 6-06, 6-WSM, 250-3000AI, 270, 7-08, 7RM, 30BR, 308, 30-06, 375 H&H, 444 Marlin, 450BM, 458WM
Thanks for the help. Had a little trouble getting the bolt started again. I will pick up a tap and die to clean up the threads. Papalote.
You need to de-cock and start the threads. Then use the edge of a workbench to cock it.
Here is something you might be interested in
http://www.amazon.com/28-Tap-Die-Set...s=1%2F2-28+tap
A tap won't do much good in the bolt body...they are just as hard as the tap.
"As long as there's lead in the air....there's still hope.."
Bookmarks