For the Long actions since the screw spacing is the same either way, to make a CF fit a SF all that should be required is a little material removal in the mag well area (for the blind mag). IIRC it is just removing a bit of material in the front of the mag well. A dremel and rasp bit should do it for you.
FWIW if you were going to put a CF action/mag in a SF stock (Long action only of course) you would have to shim or epoxy bed the mag in as the CF mag body is smaller than the SF mag well. Also this is not applicable for the Short Actions due to the different screw spacings between SF and CF.
Bookmarks