I am trying to mount new scope and rings to my savage 110.

I am running into a ring alignment issue that I am concerned is too much to be fixed with lapping. See the pictures below. This much off I really want to align bore them concentric, then take a bit off the caps to get the size right, but I am not even sure if gun smiths do this.

The rings are 1 piece Talley’s so I there really isn’t any adjustment in them. I have messed around with trying to get them concentric before tq’ing, but it hasn’t really helped. Other ideas I have is to enlarge the mounting holes a bit and align them before tq’ing, or tq them down with my lapping bar then heating them, neither of which I like.

What do you guys do when you run into this?

Thanks!

Top(plan) View:



Side View: