Rifle was a 111 trophy hunter XP, 25-06. It shot great from the factory and I really seem to like the quarter bore....so it replaced my Xbolt as my go to rifle.
I replaced the stock with the Hogue overmold, pillars only.
I bedded the action, floated the barrel and tang (Devcon).
Burris 2 piece bases, Signature Zee rings (high).
Swarovski PH 4-16X50 scope.
NSS recoil lug.
Factory Remington 100gr. core lokt psp.

I left the 0* offset's in. I set my target out at ~25 yards. First shot was 5.5" high and 4.5" to the left. On my 4th shot I got it down to .75" and 2" left then ran out of windage.

Is there something wrong (did I do something to throw my alignment off)? Even though the scope was sighted in for my Xbolt 270wsm, I shouldn't have run out of adjustment (I don't think I should have).
Or
Do I just re-center the scope (optical zero) and use the offset's to bring my POI to my POA?

I pulled the scope to check torque on the bases and rings, they are still tight (I lock tighted them on when I did the initial install)