Hello all,
I'm about to embark on carving up my first stock blank. I've watched videos and researched out the wazoo but can't seem to find answers to my last couple questions.
First, i want to build a single shot out of an action that isn't. Not a real problem.. Just don't inlet for the magazine i don't want right? But the problem arises when i want to glass bed. How do i keep the compound from going up the big hole in the bottom of the action? Saw a video of a guy using plumbers putty to fill void but that seems like a bear to clean out.i would like to avoid buying one of those costly conversion kits if possible.
Second, i would like to both pillar and glass bed. Do i do this at the same time or one before the other? If at the same time, how do i keep compound from flowing between pillar and receiver assuming i follow the attach pillars to receiver and lower the whole thing into compound in stock route?
Last, would it make more sense not to inlet for the trigger before bedding? It would be one less void to plug and i could just inlet through the compound right?
Reply With Quote
Bookmarks