I forgot how involved it is to resize 30-06 brass into 300 Savage. One displaces those memories that would otherwise make you do something else.

1) full length resize the 30-06
2) anneal the case necks
3) cut down the necks just in front of the shoulder
4) remove burs
5) lube and first pass with the sizing die
repeat 5 at least 4 more times
6) use 30-06 full length sizing die with expander to open up the case mouths
7) trim brass with cutoff wheel
8) final trim with Lee trimmer
9) deburr and chamfer
10) Turn the necks

Obviously, these need to be done in batches. I did 10 at a time for each step and it took me over an hour. That was including a couple of test cases that I ruined. (once fired range brass is perfect for this)

But in the end, they look outstanding and feed flawlessly in my 50's era Savage 99.

My goal to have 100 of these might be more ambitious than first thought.