i've spent the past hour searching this topic... i can't believe i'm the only one to have this problem, please feel free to point me to an existing link with info


yesterday I started to install my new talley 1-piece scope base/rings. after taking off the existing worthless factory
rings/bases, I noticed 3 of the 4 scope base holes were completely stripped, or partially cross-threaded.

I was able to remove the stripped threads from the receiver, clean them up a bit, a tiny bit of red loctite, force in new screws and torque them down. after shooting, it still seems to be holding.

I just bought the rifle in January. brand spanking new. what the heck?! is this a common problem from the factory? based on the fact that the front hole is directly above the barrel and cannot be re-tapped without removing the barrel... it appears I have no choice but to take it all down to a bare receiver, drill and re-tap?