Hey folks,

I ordered a EGW 1 piece scope base (linked from this forum), and went to install it on my rifle, and I noticed that the rear of my receiver (flat back 110) is not 'flat'. I'm assuming there's nothing wrong with the mount, because on closer inspection, you can actually see it. This is the best picture that I could get with my cell phone:



The rear of the mount is touching the receiver, but the front edge of the rear is not. The gap at the very front right (non-bolt side) is .023, and it tapers down to no gap at the rear. The front, which is on the round part of the receiver seems to be fine. I'm wondering if bedding the rear with JB Weld, or something can be done here, or is the gap too big? Are there any other options?