I've got some pillars being custom machined for the rifle now. It cost me a lb of varget :) They're .5" in diameter, .3" holes, front has a .4" counter bore .4" deep. They will be knurled around the middle of the pillars to hold only the bedding material. I'll have to either cut the pillar for the rear to make room, or modify the trigger to clear the uncut pillar. I havent fully decided which action I want to take. Cutting the pillar makes more sense to me. Measured to to flush fitting to the bottom of the stock. I'll be doing a full bedding job as well using devcon 10110.
.308, 1:10 twist rate, 24" barrel, heavy sporter contour.. .716" at the muzzle with a recessed crown.
Reply With Quote
Bookmarks