I have a FLCP-K in 308 that I just bought and plan to run under the new Bushnell HDMR scope which has a 34mm tube. I bought a EGW base which fits great and then based on the ring chart online I ordered a Warne High Maxima ring set. When I put the scope on with this setup the scope objective is so high above the barrel that I cant even get a decent cheek weld on the stock and see through the scope. In looking at various rings there are some "low" rings but they are not that much lower than the high, maybe .250" lower. I didnt measure the clearance on the scope objective between it and the barrel but I bet it was at least .5-.625". I finally ordered a set of LOW American Rifle rings (super cool by the way) but I am not expecting them to be low enough honestly.

What have you used on your FLCP-K as far as rings and base for a 30 or 34mm scope tube?

Anyone?