last night I took my rifle out and checked everything. the screw that goes into the action from the stock, sits flush inside the action, so I believe that I over tightened it a bit and therefore that it would rub the bottom of the bolt slightly. I will investigate it further I may need to take a thread or. two of my screw, or possibly put a small shim in behind the head of the screw, so that it will not go as far in. I did notice that it looks like the head of the screw does not sit recessed in the stock as much as the front one on the other side of the trigger guard. I make contact savage and see what would be the best route to take.