That sounds like a problem the factory should take care of.
Hello All!
I'm new to the forum but not new to savage. I recently purchased A 111 LRH chambered for .338 LM. After unboxing I noticed that the muzzle brake is indexed a little to far clockwise and it drives me nuts. It would make me feel better to know that somebody else has this same issue. Or maybe somebody knows somebody who has this problem?
Thanks for Reading!
That sounds like a problem the factory should take care of.
Any clod can have the facts; having opinions is an art.
just how is it to far clockwise? there should be 48 holes in 12 sets of 4. it does not really have any real spot it goes in ???????? just as long as you can open and close it is all that matters
Last edited by M.O.A.; 09-13-2012 at 03:21 PM.
On the .338 LM it has a traditional side port muzzle brake, not the savage brake that is on their hunting rifles.
Any clod can have the facts; having opinions is an art.
On I see send it back to savage or take it to a Smith
IDK what the setup you have is like, but can you use a washer to index, like on an AR? If so, any place that sells muzzle devices ought to have crush or peel washers for your thread size diameter.
Are you sure it didn't come set up that way to offset the rotational torque of that cannon?
A good wife and a steady job has ruined many a great hunter.
I would just call the factory and ask to speak to a tech or maybe sharpshooter will chime in as he is one of the experts.He knows them inside and out. Or call jim briggs at northland supply at:1-763-682-4296 . He (jim) is very knowledgable and he will call you usually in the evening as during the day he is busier than heck.
Willing to give back for what the sport has done for me!
ive used .001" shim stock and cut to fit both thread and brake diameters. it cuts with scissors, and works well and is perfectly parallel
Shimming it will certainly work, but I believe the biggest hurdle will be getting the muzzle brake off of the rifle. It can be removed but most of them are a bear to turn.
Any clod can have the facts; having opinions is an art.
Sounds like a "production rifle" issue, but how far is it "off"? Maybe you're like me, as a contractor, I just can't stand anything that out of plumb, square or level visually...just bugs me...even though it might not be detrimental from a practical perspective- so I get where you're coming from.
I would call the factory as suggested....and ask what they would do to fix it. Too far clockwise means they've removed too much shoulder from the barrel.
Probably, they would just install a crush washer, which you could do yourself.
Timing a brake without using one is definitely a precision operation.
Hello tobnpr,
Sorry for the very long delay, but my work schedule is crazy (factory shift). The brake is only about 1/8" to far CW and there is a crush washer installed, probably going to have to use a peel type washer to get it perfect. I too work with my hands and take lots of pride in my work. It does bother me when others don't do the same. I will call Savage today and see what they suggest. Thanks for the reply.
Bookmarks