Ok I guess I have a bit of confusion when I am reading some of this then. Lots of the videos I've seen refer to bedding points such as right behind the recoil lug and at the rear of the action, but when they put the epoxy in the stock they just slather it in and mash the barreled action in there and let it sit. How do you specifically bed certain portions? Do I only put the epoxy behind the recoil lug and at the back of the action?

I was only planning on skim bedding since its a synthetic stock, but if I were to pillar bed would I need at least 2? One at the front of the trigger and one in front of the magazine? I just need to find something that fits around the bolt closely and isnt too large of a diameter?