I have had the urge for a LR 243 and normally I just use a smith to twist it up on a Remy or Stiller action. Anyway I was perusing the FS sections and ran across this little jewell. Figure for the money its worth a shot at doing it myself this round. I would answer these questions myself but the rifle is in TX and I am in Kabul.

#1, Screw hole spacing, this is a 10XX scout but non accutrigger. Will this have the 4.27 or 4.4 spacing?

#2 Barrel Tenion, I am 100% sure its a small, anyone disagree with that?

I plan on ordering a McM HTG for this project, and getting either a Krieger or Brux barrel. Also using a CDI DBM

Other than a trigger and lug is there anything else that should be up for replacement? Thanks for the input

And a pic of the rifle in Question, its a 7mm-08 Scout