After reading this post http://savageshooters.com/SavageForu...c,45001.0.html, I was curious.

I pulled my 10FCM action out of the accustock and checked. While I don't have the problem described in that post, I have determined that the front of the action, even when torqued down, is not touching the accustock aluminum bedding material at the front lug. Instead, the bottom of the recoil lug is bottoming out on the aluminum accustock frame first.

I don't know if this is affecting accuracy as I only shoot this rifle with open sights, but the barrel is not parallel with the center line of the stock and I think this may be the reason why.

I came up with the following three possible solutions. Which of them do you think would be better? (Or is there something else I haven't thought of that I could/should do?)

a) file down the bottom of the recoil lug so it doesn't bottom out.
b) put a shim between the accustock metal and the action at the front action screw.
c)make the cut for the recoil lug deeper so the lug doesn't bottom out.

Thanks