Are you supposed to anneal the brass first, then size it or does it not really make a difference? I started annealing my brass about 4 or 5 months ago. I get more use out of it and, it seems to help with consistancy as well. I noticed a bit of distortion when I annealed freshly sized / cleaned brass. Distortion, such as I notice a bit of wobble in the bullet when I roll it across the bench top. This occured in about 2 or 3 rounds out of 10. When I anneal before sizing / cleaning, I notice very few, if any that distort. Additionally, when I annealed after sizing, I got a few cases that are hard to chamber and there's noticeable marks on the case where it's rubbing on the chamber when cycled. Certainly this would affect accuacy, I would think. Considering the info I just gave, one would expect it's best to anneal then size & clean & load then, shoot. I was wanting to hear from some of you folks on your standard operating procedure with reloading / annealing. Since I'm a little "green" on reloading as I am still developing my SOP for reloading & annealing.
Other Info: Cases discussed - .270 win & 30-06
Method of annealing - propane torch & battery drill with socket
Length of time reloading - 1.5 years
Severity of addiction to reloading - very severe
Severity of addiction to Savage firearms - hopeless
Have a safe & Happy Thanksgiving everyone!!!