Primary Extraction Failure-- swapping bolt handle didn't help
So I've got essentially zero primary extraction on my target rifle. It shoots well; it's just that I have to hammer the bolt open with a mallet after every shot these days.
I read all the threads on here, and it sounds like the corrective options are:
1.) Replace the bolt handle with one that's in spec.
2.) Shorten the bolt body.
3.) Add some set screws in a location I've yet to figure out.
I bought the Tactical Works bolt handle, which helped not at all. Nice bolt handle; I'll keep it for another project.
Shortening the body sounds difficult, as does the set-screw fix. Surely there is an off-the-shelf solution that fixes this problem? It must be an extremely common problem, based on the posts here. Is there no bridge, bolt body, or oversized bolt handle out there?
Thanks.
Kuduman