no one has any advice?
Hello all
I have a model 11 300wsm with the control feed action.
every other round that I cycle the front of the round jumps up too high and it
jams. If I pull back a little and push it, it goes in, if I pull back to far
it ejects.
fast cycles are a real problem. it can be the first or the last there is no order in when it happens.
Is there a fix for this or is there I should be checking?
Thank you for the help
no one has any advice?
You could try to lightly bend the feed lips in on the front. It depend on how high the round is sitting. Pull the bolt out and look down the bolt raceway. You might need to bend the back in also to keep it straight. Measure and do a little at a time.
The Dunning-Kruger effect is alive and well.
^^^^^this...
by watching what the cartridge is doing, it's easy to figure out.
thank you I will try that.
I also just got my action taps from pacific tool, I will let you know how they work
Thanks again
I have a question about your action Taps. PM sent
The Dunning-Kruger effect is alive and well.
Yes, let us know!
Bookmarks