I have a model 10 LE that I had to replace the extractor and ball on. Now my model 110 6.5 CM that won't extract. I can't remember where to buy the kit. Any advise appreciated
I have a model 10 LE that I had to replace the extractor and ball on. Now my model 110 6.5 CM that won't extract. I can't remember where to buy the kit. Any advise appreciated
Google "Savage Extractor"...
Midway
Tactical Works
Savage Sharpshooters Supply
Kinneys Shooting Supply
Gunshack
You replaced it already & now it won’t extract? If that’s the case, I doubt another will fix it.
On the other hand, if you are asking where to buy, because it hasn’t yet been done, better to do a new extractor with an over sized bearing ball. A .140” ball works perfectly. Can find 9/64” steel balls, or a 3.5mm works well also. I use the Silicon Nitride 3.5mm bearing balls from Amazon.
Here’s the full kit. https://www.gunshack.com/savage-part...head-parts-kit
Brownells has the just the Extractor. https://www.brownells.com/rifle-part...prod12817.aspx
I need to make this a little clearer. I have a savage in 308 that I had to replace the extractor and ball on. Now my savage in 6.5 CM is not extracting spent cases. I wanted the bigger ball set and not an original sized extractor and ball. I believe the ball that works is a .940 size ball. Is that correct?
Yes... .140” or 9/64”. 3.5mm also works quite well at just under .138”.
These are the standard 9/64” https://www.amazon.com/uxcell-Precis...245942&sr=8-18
These work well, 3.5mm Tungsten Carbide. https://www.amazon.com/3-5mm-Tungste...9245738&sr=8-3
These are what I use. https://www.amazon.com/3-5mm-Silicon...9246067&sr=8-6
Bookmarks